As we’re getting ready for the Ocarina of Time remake, I thought this would be a fun little print! Too bad I put the label on upside down…
It was challenging to get the label to bend properly, I heated the printer bed and used that to bend it since I didn’t have a heat gun at the time.
The bottle also had a lot of internal supports that were really tricky to remove; I had to cut them into pieces before extracting them with needle nose pliers, kind of a pain.
Project details
- Craft: 3D print
- Status: Finished
- Difficulty: Quick
- Started: November 5, 2026
- Finished: November 6, 2026
- Model: Model file
- Pattern rating: ★★★★☆
- Materials: PLA matte
- Would make again? Yes









Leave a Reply